Canon Finisher-AB1 Service Manual page 141

6) The preparations for the paddle height adjustment
are completed by pressing the push switch
SW385 [1].
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-112
7) The adjustment amount is determined by pressing
either one of the push switches: SW383 [1] or
SW384 [2].
When SW383 is pressed once, "-1" appears on the
LED [3], and the staple inelt guide height position
[4] is lowered.
On the other hand, when SW384 is pressed once,
"+1" appears on the LED [3], and the staple inlet
guide height position [5] is raised.
o Adjustment range: +4 to -4 (Each 1 setting
value change results in the movement of 0.5mm.)
<Reference>
When the foregoing fault has occurred, it can be
remedied by changing the adjustment value in the
negative direction.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-113
[1]
[3]
F-5-114
7) The adjustment amount is determined by pressing
either one of the push switches: SW383 [1] or
SW384 [2].
When SW383 is pressed once, "-1" appears on the
LED [3], and the staple inelt guide height position
[4] is lowered.
On the other hand, when SW384 is pressed once,
"+1" appears on the LED [3], and the staple inlet
guide height position [5] is raised.
o Adjustment range: +4 to -4 (Each 1 setting
value change results in the movement of 0.5mm.)
<Reference>
When the foregoing fault has occurred, it can be
remedied by changing the adjustment value in the
negative direction.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-115
Chapter 5
[5]
[4]
[1]
5-35