Canon Finisher-AB1 Service Manual page 364

Chapter 5
6) Press the push switch SW3851 [1] to start
adjustment of the front aligning plate width.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-40
7) Place A4 paper [1] in the intermediate handling
tray. (Be sure to butt the paper against the rear of the
handling tray.)
F-5-41
8) Press the push switch SW383 [1] or SW384 [2] to
store the new value.
A single press on SW383 will cause the LED [3]
to indicate '-1', moving the front aligning plate [4]
by about 0.2 mm toward the front. On the other
hand, a single press on SW384 will cause the
LED [3] to indicate '+1', moving the front
aligning plate [4] by about 0.2 mm toward the
rear.
range of adjustment: +10 to -10 (unit: 0.2 mm)
5-16
SW382
SW381
[1]
[1]
[1]
9) Press the push switch SW385 [1] to store the
distance of travel of the front aligning plate.
SW382
SW381
[3]
SW383 SW384 SW385
(-) (+) ENTER
[2]
[4]
F-5-42
SW383 SW384 SW385
(-) (+) ENTER
F-5-43
[1]