Adjusting The Aligning Plate Width - Canon Finisher-AB1 Service Manual

5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-34
6) Press the push switch SW385 [1] to start
adjustment of the swing guide speed.
In a while, press the push switch SW385 [1]; if
the LED [2] indicates '0', the adjustment has
ended successfully.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-35
7) If the LED indicates other than '0', the result is not
good. Repeat the steps.
[2]
[1]

5.3.2.5 Adjusting the Aligning Plate Width

Go through the following steps if you have replaced
the front alignment motor or the rear alignment
motor or the EEPROM of the controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-36
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-37
Chapter 5
[1]
5-13
0015-2230
[1]