Canon Finisher-AB1 Service Manual page 183

Code Detail Occurrence
code classification
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E509 Software compatibility malfunction
0002 02
0003 02
0004 02
E514
8001 02
8002 02
Inserter malfunction or stacker feed motor error
E515
8001 02
(Inserter)
8002
8003
8004
8005
8006
Description
Boot ROM malfunction
Non-supported option (professional
puncher) connected
Non-supported option (trimmer B-1)
connected
ASSIST operation error
ASSIST HP sensor does not come
ON within 5 sec. after ASSIST
motor operation begins.
ASSIST HP sensor does not go OFF
within 5 sec. after ASSIST motor
operation begins.
Switching gear does not clear drive
switching sensor home position after
the drive switching motor has been
running for the prescribed interval.
Switching gear does not reach drive
switching sensor home position after
the drive switching motor has been
running for the prescribed interval.
Tray A does not clear home position
after tray A lifter motor has been
running for the prescribed interval.
Tray A lifting motor does not reach
the home position after the lifting
motor has been running for the
prescribed interval.
Tray B does not clear home position
after tray B lifter motor has been
running for the prescribed interval.
Tray B lifting motor does not reach
the home position after the lifting
motor has been running for the
prescribed interval.
Treatment/ detection timing
Replace the finisher controller PCB with the correct
one.
Remove the EEPROM from the old board and mount
it on the new board.
Remove professional puncher.
Connect trimmer C-1.
- Check ASSIST HP sensor connectors.
- Check ASSIST motor connectors.
- Replace ASSIST HP sensor.
- Replace ASSIST motor.
- Replace finisher controller PCB.
- Check ASSIST HP sensor connectors.
- Check ASSIST motor connectors.
- Replace ASSIST HP sensor.
- Replace ASSIST motor.
- Replace finisher controller PCB.
Check drive switching motor connectors, replace.
Check drive switching motor connectors, replace.
Check tray A lifting motor connectors, replace.
Check tray A lifting motor connectors, replace.
Check tray B lifting motor connectors, replace.
Check tray B lifting motor connectors, replace.
Chapter 6
6-3