Process Tray - Canon Finisher-AB1 Service Manual

A guide [2] is attached so that it may not run aground
on a lever [1].
[2] [1]
F-4-81

4.4.3 Process Tray

4.4.3.1 Before Removing the Handling
Tray (front/rear)
1) Remove the stacking wall (upper). (page 4-
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
20)Reference[Removing the Handling Tray
Unit]
4.4.3.2 Removing the Handling Tray (front)
1) Shift the handling tray aligning plate (front) [1] in
the direction of the arrow; then, remove the screw
[2] and the claw [3] to detach the handling tray
aligning plate (front).
[2] [1]
0015-2167
the Stacking Wall
the Stacking Wall
0015-2168
[3]
[1]
F-4-82
2) Remove the handling tray (front) [1].
- 2 screws [2]
[1]
F-4-83
Chapter 4
[2]
[2]
4-21