Canon Finisher-AB1 Service Manual page 403

12) Stapling is executed by pressing the push switch
SW384 [1] several times.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-183
13) The sheets are folded and delivered by pressing
the push switch SW383 [1] several times.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-184
14) Based on the output results, measure the degree
of misalignment [A] or [B] between the rear
staple position [1] and the front staple position
[2].
If the degree is significant, follow the steps below
to adjust the tilting of the saddle staple unit.
[1]
[2]
F-5-185
15) Loosen the 2 screws [1] used to secure the saddle
staple unit.
[2]
F-5-186
16) Adjust the tilting of the saddle staple unit in
accordance with the degree of misalignment in
the staple positions.
- If, as described in step 14), the front staple
position has shifted downward (the degree of
misalignment [A])
Action to take:
Move the staple unit [1] in the direction of the
black arrow [A] by an amount equivalent to the
shift.
- If, as described in step 14), the front staple
position has shifted upward (the degree of
misalignment [B])
Action to take:
Move the staple unit [1] in the direction of the
white arrow [B] by an amount equivalent to the
shift.
17) Return the finisher to the operable status by
following steps 1) to 8) and step 15) but in reverse.
Chapter 5
[2]
[1]
[A]
5-55
[B]
[1]