Canon Finisher-AB1 Service Manual page 376

Chapter 5
[3]
F-5-82
F-5-83
[1] 1st sheet
[2] 2nd sheets
[3] 3rd sheets
10) If A (between 1st and 2nd sheets) or B (between
2nd and 3rd sheets) is not as indicated, go through
the following:
Press the push switch SW385 [1] so that the
machine is in adjustment mode for A (between 1st
5-28
[2] [1]
[3]
[2]
[1]
[B] [A]
and 2nd sheets). Press the push switch SW383 [2]
to decrease the displacement, or press SW384 [3]
to increase the displacement. (The LED [4]
indicates the correction value.)
range of adjustment: +30 to -30 (unit: 0.2 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[2] [3]
F-5-84
11) If B (between 2nd and 3rd sheets) is not as
indicated, go through the following:
Press the push switch SW385 [1] so that the
machine is in adjustment mode for B (between 1st
and 3rd sheets).
Press the push switch SW382 [2] to decrease
the displacement, or press SW384 [3] to increase
the displacement. (The LED [4] will indicate the
correction value.)
range of adjustment: +30 to -30 (unit: 0.2 mm)
Another press on SW385 will store the A/B
correction value.
[4]
[1]