Adjusting The Speed Of The Swing Guide - Canon Finisher-AB1 Service Manual

Chapter 5
5.3.2.4 Adjusting the Speed of the Swing
Guide
Go through the following steps if you have replaced
the swing guide motor or the EEPROM of the
finisher controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-32
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-33
5-14
[1]
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
0015-2229
SW382
SW381
SW383
(-)
[1]
6) Press the push switch SW385 [1] to start
adjustment of the swing guide speed.
In a while, press the push switch SW385 [1]; if
the LED [2] indicates '0', the adjustment has
ended successfully.
SW382
SW381
SW383
(-)
7) If the LED indicates other than '0', the result is not
good. Repeat the steps.
SW384 SW385
(+) ENTER
F-5-34
[2]
SW384 SW385
(+) ENTER
[1]
F-5-35