Adjusting The Sensor Intensity - Canon Finisher-AB1 Service Manual

Chapter 5

5.3.1.3 Adjusting the Sensor Intensity

Go through the following steps when installing the
finisher or replacing specific sensor:
1) Turn on the finisher and the host machine in
sequence.
2) Open the front cover, and insert the door switch
actuator into the door switch [1].
F-5-21
3) Insert a screwdriver [2] through the hole [1] in the
bottom face of the tray; then, disengage the tray in
the direction of [A], and lower the tray A/B in the
direction of [B].
[2]
F-5-22
Be sure to lower the tray A/B [2] until it does not
block the tray sensor (front/rear) [1].
5-10
0015-2224
[1]
[1]
[B]
[A]
[1]
[2]
F-5-23
4) Detach the inside cover (lower) and the switch
cover [1].
- 1 screw [2]
[2]
F-5-24
[1]
[2]
[1]