Canon Finisher-AB1 Service Manual page 230

2) Connect the ARCNET cable [1] to the terminal [2]
at sub station, and then turn the finger grip [3] in
the direction of the arrow to connect.
Rotate the ARCNET cable until they are fully
fixed, or the electrical contact can be unstable.
3) Put the end terminal connector [2] and the
ARCNET cable [3] to the coaxial connector [1],
and turn each of then in the direction of the arrow
to connect.
[3]
4) Connect the ARCNET cable [1] to the terminal [2]
at finisher, and then turn the finger grip [3] in the
direction of the arrow to connect.
[3]
[1]
[2]
F-2-22
[1]
F-2-23
Be sure to turn off the host machine and unplug the
power supply cable when connecting the ARCNET
cable.
5) Attach the wire saddle [1] to the rear lower cover
of the finisher to bundle the signal cable [2] on it.
[2]
[2]
[2]
F-2-24
[2] [1]
F-2-25
Chapter 2
[3]
[1]
2-9