Making Adjustments; Height Adjustment - Canon Finisher-AB1 Service Manual

2.3 Making Adjustments

2.3.1 Height Adjustment

Depending on the floor condition of an installation
site, you should adjust the height of the finisher. If
not properly adjusted, paper might be jammed more
frequently in the feeder assembly. Follow the steps
below to adjust the height when it is necessary.
1. 1. Checking the height
1) Check the height of the finisher and the main
station. The height difference between the right
top of the finisher [1] and the left top of the main
station [2] should be within 2mm.
[1]
F-2-28
0016-1444
[2]
2) If the difference exceeds 2mm, adjust the height.
Adjust the height with 4 casters [1] as shown
in the figure.
[1]
2. Height adjustment
1) Disconnect the finisher from the main station.
2) Remove the wrench [1] from the finisher front
cover.
- 1 screw [2]
[1]
[2]
F-2-29
Chapter 2
[1]
2-11