Canon Finisher-AB1 Service Manual page 121

8) Press the push switch SW383 [1] or SW384 [2] to
store the new value.
A single press on SW383 will cause the LED [3]
to indicate '-1', moving the front aligning plate [4]
by about 0.2 mm toward the front. On the other
hand, a single press on SW384 will cause the
LED [3] to indicate '+1', moving the front
aligning plate [4] by about 0.2 mm toward the
rear.
range of adjustment: +10 to -10 (unit: 0.2 mm)
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-42
[3]
[4]
9) Press the push switch SW385 [1] to store the
distance of travel of the front aligning plate.
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
F-5-43
10) Check that there is no gap between the paper and
the aligning plate as the result of the foregoing
steps. If there still is a gap, go back to step 8).
F-5-44
Chapter 5
[1]
[1]
[2]
5-15