Positioning Plate Unit; Belt Controller Unit - Canon Finisher-AB1 Service Manual

Table of Contents

Advertisement

4.3.7 Positioning Plate Unit

4.3.7.1 Before Removing the Positioning
Plate Unit
1)
Remove
the
35)Reference[Removing the Stop Unit]
4.3.7.2 Removing the Positioning Plate
Unit
1) Disconnect the cable [1].
- 3 connectors [2]
- 2 clamps [3]
- 2 reuse band [4]
[1]
[3]
[4]
F-4-66
2) Remove the positioning plate unit [1].
- 2 screws [2]
F-4-67

4.3.8 Belt Controller Unit

4.3.8.1 Before Removing the Belt
Controller Unit
1) Remove the stacking wall (upper). (page 4-
(page
stop
unit.
[2]
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
0015-2307
23)Reference[Removing the Handling Tray
4-
Unit]
4) Remove the middle rear cover. (page 4-
7)Reference[Removing the Middle Rear Cover]
4.3.8.2 Removing the Belt Controller Unit
0015-2308
1) Loosen the screw [1].
[1]
[2]
2) Free the cable from the 4 clamps [1] and the edge
saddle [2]; then, disconnect the 3 connectors [3].
[3]
[1]
[2]
[2]
[3]
0015-2309
Chapter 4
the
Stacking
the
Stacking
F-4-68
[1]
[1]
[1]
F-4-69
Wall
Wall
0015-2310
[3]
4-17

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Saddle finisher-ab2

Table of Contents