Rear Alignment Motor - Canon Finisher-AB1 Service Manual

5) Remove the handling tray (front) [1].
- 2 screws [2]
[1]
F-4-32
6) Loosen the screw [1], and free the belt [2] from the
gear [3].
[3]
F-4-33
7) Remove the aligning motor (front) [1].
(page 5-11)Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-13)Reference[Adjusting the Aligning
Plate Width]
- 2 clamps [2]
- 1 connector [3]
- 2 screws [4]
[2]
[2] [1]
[2]
[1]
F-4-34

4.3.3 Rear Alignment Motor

4.3.3.1 Before Removing the Alignment
Motor (rear)
1) Remove the stacking wall (upper). (page 4-
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
20)Reference[Removing the Handling Tray
Unit]
4.3.3.2 Removing the Alignment Motor
(rear)
1) Free the cable [2] from the 3 clamps, and
disconnect the connector [3].
[2]
F-4-35
Chapter 4
[3]
[4]
the Stacking Wall
the Stacking Wall
0015-2302
0015-2303
[1]
[3]
4-9