Adjusting The Aligning Plate Width - Canon Finisher-AB1 Service Manual

5.3.2.5 Adjusting the Aligning Plate Width

Go through the following steps if you have replaced
the front alignment motor or the rear alignment
motor or the EEPROM of the controller PCB:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-36
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-37
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
for A-Series,
[1]
[1]
0015-2230
SW382
SW381
SW383
(-)
[1]
for L-Series,
[1]
SW382
SW381
SW383 SW384 SW385
(-)
F-5-39
Chapter 5
SW384 SW385
(+) ENTER
F-5-38
(+) ENTER
5-15