Adjusting The Horizontal Registration/Angle - Canon Finisher-AB1 Service Manual

7) Press the enter button to end adjustment mode.
8) Turn off the host machine and then the finisher in
sequence.
2. Adjusting the Horizontal Registration
1) Disconnect the finisher from the host machine.
2) Loosen the 2 screws [2] on the positioning plate
[1] found on the right side.
3) If the value recorded is on the + side, move the
plate in the direction of [A] and tighten the screw
[2].
If the value recorded is on the - side, on the other
hand, move the plate in the direction of [B] and
tighten the screw [2].
[2]
[B]
F-5-16
[1]
[A]
3. Adjusting the Angle
If the angle is as indicated, start with step 7).
1) Lift the upper cover [1], and detach the inside
cover (upper) [2].
- 1 knob [3]
- 8 screws [4]
[3]
[2]
F-5-17
2) Loosen the 2 screws [2] on the latch base (front)
[1].
3) If the value recorded is on the + side, move the
base in the direction of [A] and tighten the screw
[2].
If the value recorded is on the - side, on the other
hand, move the base in the direction of [B] and
tighten the screw [2].
Chapter 5
[4]
[1]
[4]
5-7