Installation Procedure; Points To Note When Turning On/Off The Power Of Host Machine; Before Installing Finisher - Canon Finisher-AB1 Service Manual

2.2 Installation Procedure

2.2.1 Points to Note When Turning
ON/OFF the power of Host
Machine
Power-On Order for Turning On the
Power When Pickup/Delivery Accessories
are Connected
Be sure to turn on the power in the correct order
otherwise it may cause an error because the host
machine fails to recognize accessories
including this equipment.
<Power-On Order>
1) Accessories (accessories including this
equipment)
2) Host machine
MEMO:
There is no power-on order among accessories
Points to Note When Turning Off the
Main Power of the Host Machine
Be sure to turn off the main power in the
following order to protect hard disk of the
host machine.
1) Press the power switch on control panel for
3 sec or more.
2) Follow the instruction on the shutdown
sequence screen (the main power switch will
go off automatically).
3) Turn off the breaker.
4) Disconnect the power plug.

2.2.2 Before Installing Finisher

1) Open the front cover of the finisher.
2) Remove 1 screw [2] from the front latch retainer
[1].
0016-5236
3) Detach the rear small cover [1].
- 4 screws [2]
[1]
[2]
Chapter 2
[2]
F-2-2
[2]
F-2-3
0016-0901
[1]
2-3