Bridge Multicast Ipv6 Ip-Address - Cisco Sx350 Cli Manual

4
137
switchxxxxxx(config-if)#
ip-group

4.10 bridge multicast ipv6 ip-address

To register an IPv6 Multicast address to the bridge table, and statically add or
remove ports to or from the group, use the bridge multicast ipv6 ip-address
Interface (VLAN) Configuration mode command. To unregister the IPv6 address,
use the no form of this command.
Syntax
bridge multicast ipv6 ip-address
interface-list |
port-channel
no bridge multicast ipv6 ip-address
Parameters
•
ipv6-multicast-address—Specifies the group IPv6 multicast address.
•
add—(Optional) Adds ports to the group.
•
remove—(Optional) Removes ports from the group.
•
ethernet interface-list
Separate nonconsecutive Ethernet ports with a comma and no spaces; use
a hyphen to designate a range of ports.
•
port-channel port-channel-list
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
bridge multicast ipv6 mode
ipv6-multicast-address
port-channel-list
}]
ip-multicast-address
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands
[[add | remove] {ethernet