Use The Router Transport Kit To Install The Router In An Open-Frame Rack - Juniper MX2010 Manual

NOTE: A four-person team is needed to carefully guide the router into the rack while
operating the winch.
NOTE: If the router is not pulled all the way into the rack by the winch mechanism, grasp
the handles on the shipping covers and carefully slide the router onto the mounting shelf
until the front-mounting flanges contact the rack rails. You must remove the winch bracket
to perform this procedure.
NOTE: There must be a minimum of 45-U of usable rack space when installing the MX2010
into a 45-U rack.
11. Remove the router transport platform, and set the platform aside.
12. Remove the winch mount and winch strap plate, and set them aside.
13. Insert twelve mounting screws (six on each side) into the mounting holes to secure the router to the
rack.
14. Visually inspect the alignment of the router. To verify that the router is installed properly in the
rack, see that all the mounting screws on one side of the rack are aligned with the mounting screws
on the opposite side and the router is level.
15. Reassemble the router transport kit, and set it aside.

Use the Router Transport Kit to Install the Router in an Open-Frame Rack

NOTE: Four persons are needed to install the router into a rack.
CAUTION: Before front-mounting the router in a rack, have a qualified technician verify
that the rack is strong enough to support the router's weight and is adequately
supported at the installation site.
To install the MX2010 in an open-frame rack by using a router transport kit:
1. Using the router transport platform, position the router in front of the rack or cabinet, centering it
in front of the rack.
2. Using a four person team, transport the router to the rack installation location and center it in front
of the rack.
48