Static Route Add/Edit Screen - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

The following table describes the labels in this screen.

Table 120 Device Operation > Device Configuration > Network > Routing > Static

Total Records

9.11.1 Static Route Add/Edit Screen

Select a static route index number and click Add or Edit. The screen shown next

appears. Use this screen to configure the required information for a static route.

Figure 136 Device Operation > Device Configuration > Network > Routing > Static

Vantage CNM User's Guide

Select how many entries you want to display on each page.

This is the number of an individual static route.

This is the destination IP address.

This is the IP subnet mask.

This is the IP address of the next-hop gateway or the interface through

which the traffic is routed. The gateway is a router or switch on the same

segment as your ZyWALL's interface(s). The gateway helps forward

packets to their destinations.

This is the route's priority among the ZyWALL's routes. The smaller the

number, the higher priority the route has.

Click the Add icon to go to the screen where you can set up a static route

on the ZyWALL.

Click the Edit icon to go to the screen where you can edit the static route

on the ZyWALL.

Click the Remove icon to delete an existing static route from the

ZyWALL. A window displays asking you to confirm that you want to delete

the routing policy.

This is the total number of static routes.

Chapter 9 Device Network Settings