ZyXEL Communications Vantage CNM 2.3 User Manual page 68

Chapter 5 Device Network Settings
Table 17 Device Operation > Device Configuration > Network > WAN > General
(ZyNOS ZyWALL) (continued)
LABEL
Allow
between
WAN2 and
LAN
Allow
between
WAN2 and
DMZ
Allow
between
WAN2 and
WLAN
Allow Trigger
Dial
Apply
Reset
68
DESCRIPTION
Select this check box to forward NetBIOS packets from the WAN2 port to
the LAN port and from the LAN port to WAN2. If your firewall is enabled
with the default policy set to block WAN port 2 to LAN traffic, you also
need to enable the default WAN2 to LAN firewall rule that forwards
NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the WAN2
port to the LAN port and from LAN port to WAN2.
Select this check box to forward NetBIOS packets from the WAN2 port to
the DMZ port and from the DMZ port to WAN2.
Clear this check box to block all NetBIOS packets going from the WAN2
port to the DMZ port and from DMZ port to WAN2.
Select this check box to forward NetBIOS packets from the WAN2 port to
the WLAN port and from the WLAN port to WAN2.
Clear this check box to block all NetBIOS packets going from the WAN2
port to the WLAN port and from WLAN port to WAN2.
Select this option to allow NetBIOS packets to initiate calls.
Click this to save your changes back to the device.
Click this to begin configuring this screen afresh.
Vantage CNM User's Guide