Bridge Add/Edit - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

Chapter 9 Device Network Settings

Table 109 Device Operation > Device Configuration > Network > Interface > Bridge

9.4.1 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth

parameters, DHCP settings, and connectivity check for each bridge interface. To

access this screen, click the Add icon at the top of the Add column or click an

This field displays the current IP address of the interface. If the IP

address is 0.0.0.0, the interface does not have an IP address yet.

This screen also shows whether the IP address is a static IP address

(STATIC) or dynamically assigned (DHCP). IP addresses are always

static in virtual interfaces.

This field displays the Ethernet interfaces and VLAN interfaces in the

bridge interface. It is blank for virtual interfaces.

This column lets you create, edit, remove, activate, and deactivate

To create a bridge interface, click the Add icon at the top of the

To create a virtual interface, click the Add icon next to the

corresponding bridge interface.

To edit an interface, click the Edit icon next to it.

To remove an interface, click the Remove icon next to it. The

Vantage CNM confirms you want to remove it before doing so.

Vantage CNM User's Guide