ZyXEL Communications Vantage CNM 2.3 User Manual page 501

The following table describes the labels in this screen.
Table 222 Monitor > 3G Monitor > Show Details (3G down, Budget Control enabled)
LABEL
Device Name
3G Connection
Status
IP/Netmask
IP Assignment
Service
Provider
Roaming
Network
Last
Connection Up
Time
Vantage CNM User's Guide
DESCRIPTION
This is the name of the device where the 3G card is installed.
This displays Down when the 3G connection is down or not activated.
This displays Initializing when the selected device is configuring the 3G
card with AT commands.
This displays Ready to Connect when the 3G connection is idle before
the selected device triggers a call.
This displays Connecting when the 3G card is trying to connect to a
network but has not received a response from the base station.
This displays Connected when the 3G connection is up.
This displays Disconnecting when the selected device is dropping the
3G connection. This field also displays whether the selected device is
connected to a UMTS/HSDPA network or GPRS/EDGE network.
This field also displays the type of the network to which the selected
device is connected. The network type varies depending on the 3G card
you inserted and could be UMTS, HSDPA, GPRS or EDGE when you
insert a GSM 3G card, or 1xRTT, EVDO Rev.0 or EVDO Rev.A when
you insert a CDMA 3G card.
Click Dial to dial up the 3G WAN connection.
This shows the port's IP address and subnet mask.
For the WAN, if the selected device gets its IP address automatically
from an ISP, this displays DHCP client when you're using Ethernet
encapsulation and IPCP Client when you're using PPPoE or PPTP
encapsulation. Static displays if the WAN port is using a manually
entered static (fixed) IP address.
For the LAN, WLAN or DMZ, DHCP server displays when the selected
device is set to automatically give IP address information to the
computers connected to the LAN. DHCP relay displays when the
selected device is set to forward IP address assignment requests to
another DHCP server. Static displays if the LAN port is using a manually
entered static (fixed) IP address. In this case, you must have another
DHCP server on your LAN, or else the computers must be manually
configured. For the dial backup port, this shows N/A when dial backup
is disabled and IPCP client when dial backup is enabled.
This displays the name of your network service provider or Limited
Service when the signal strength is too low or the ISP is limiting your
access.
This field is available only when you insert a 3G card that supports the
roaming feature.
This displays whether the card is able to connect to other ISPs' base
stations.
This displays how long the 3G connection has been up.
Chapter 24 3G Monitor
501