ZyXEL Communications Vantage CNM 2.3 User Manual page 225

menu bar and then click Device Configuration > Advanced > Static Route in
the navigation panel.
Figure 92 Device Operation > Device Configuration > Advanced > Static Route
The following table describes the labels in this screen.
Table 85 Device Operation > Device Configuration > Advanced > Static Route
LABEL
#
Route Name
Active
Destination
Gateway
Edit
Remove
Vantage CNM User's Guide
DESCRIPTION
This is the number of an individual entry.
This is the name that describes or identifies this route. To delete a static
route, erase the name and then click Apply.
This field shows whether this static route is active or not.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This is the IP address of the gateway. The gateway is an immediate
neighbor of the device that will forward the packet to the destination. On
the LAN, the gateway must be a router on the same segment as the
device; over the WAN, the gateway must be the IP address of one of the
remote nodes.
Click this to set up a static route on the device.
Click this to delete a static route.
Chapter 7 Device Advanced Settings
225