ZyXEL Communications Vantage CNM 2.3 User Manual page 252

Chapter 9 Device Network Settings
Table 97 Device Operation > Device Configuration > Network > Interface > Ethernet
> Edit (continued)
LABEL
Downstream
Bandwidth
MTU
RIP Setting
Enable RIP
Direction
Send Version
Receive
Version
V2-Broadcast
OSPF Setting
Area
Priority
Link Cost
Passive
Interface
252
DESCRIPTION
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can receive from the network through the interface. Allowed
values are 0 - 1048576.
Maximum Transmission Unit. Type the maximum size of each data
packet, in bytes, that can move through this interface. If a larger
packet arrives, the ZyWALL divides it into smaller fragments. Allowed
values are 576 - 1500. Usually, this value is 1500.
Select this to enable RIP in this interface.
This field is effective when RIP is enabled. Select the RIP direction
from the drop-down list box.
BiDir - This interface sends and receives routing information.
In-Only - This interface receives routing information.
Out-Only - This interface sends routing information.
This field is effective when RIP is enabled. Select the RIP version(s)
used for sending RIP packets. Choices are 1, 2, and 1 and 2.
This field is effective when RIP is enabled. Select the RIP version(s)
used for receiving RIP packets. Choices are 1, 2, and 1 and 2.
This field is effective when RIP is enabled. Select this to send RIP-2
packets using subnet broadcasting; otherwise, the ZyWALL uses
multicasting.
Select the area in which this interface belongs. Select None to disable
OSPF in this interface.
Enter the priority (between 0 and 255) of this interface when the area
is looking for a Designated Router (DR) or Backup Designated Router
(BDR). The highest-priority interface identifies the DR, and the
second-highest-priority interface identifies the BDR. Set the priority to
zero if the interface can not be the DR or BDR.
Enter the cost (between 1 and 65,535) to route packets through this
interface.
Select this to stop forwarding OSPF routing information from the
selected interface. As a result, this interface only receives routing
information.
Vantage CNM User's Guide