Edit Static Route; Figure 84 Configuration > Static Route > Edit; Table 55 Configuration > Static Route > Edit - ZyXEL Communications Vantage CNM User Manual

10.1.2 Edit Static Route

Figure 84 Configuration > Static Route > Edit
Table 55 Configuration > Static Route > Edit
LABEL
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Private
Save
Cancel
Chapter 10 Configuration > Static Route
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete this static
route.
This checkbox allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate neighbor of the
ZyXEL device that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as the ZyXEL device; over the
WAN, the gateway must be the IP address of one of the Remote Nodes.
Metric represents the cost of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
This parameter determines if the ZyXEL device will include this route to a remote
node in its RIP broadcasts.
Select this check box to keep this route private and not included in RIP broadcasts.
Clear this checkbox to propagate this route to other hosts through RIP broadcasts.
Click Save to save your changes back to the ZyXEL device.
Click Cancel to return to the previous screen.
Vantage CNM User's Guide
164