ZyXEL Communications Vantage CNM 2.3 User Manual page 322

Chapter 10 Firewall
The following table describes the labels in this screen.
Table 128 Device Operation > Device Cofniguration > Firewall > Session Limit >
Edit
LABEL
Enable Rule
Description
User
Address
Session Limit
per Host
OK
Cancel
322
DESCRIPTION
Select this check box to turn on this session limit rule.
Enter information to help you identify this rule. Use up to 64 printable
ASCII characters. Spaces are allowed.
Select a user name or user group to which to apply the rule. Select
Create Object to configure a new user account. The rule is activated
only when the specified user logs into the system and the rule will be
disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies.
Select Create Object to configure a new one. Select any if the policy is
effective for every source address.
Use this field to set a limit to the number of concurrent NAT/firewall
sessions this rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default
Session per Host setting in the general Firewall Session Limit
screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Vantage CNM User's Guide