Default User Authentication Timeout Settings Edit Screens - ZyXEL Communications Vantage CNM 2.3 User Manual

Chapter 14 Object
Table 144 Device Operation > Device Configuration > Object > User/Group > Setting
(continued)
LABEL
Schedule
Source
Destination
Authentication
Add icon
Total Records
Apply
Reset
14.3.1 Default User Authentication Timeout Settings Edit
Screens
The User Authentication Timeout Settings Edit screen allows you to set the
default authentication timeout settings for the selected type of user account.
These default authentication timeout settings also control the settings for any
existing user accounts that are set to use the default settings. You can still
manually configure any user account's authentication timeout settings.
366
DESCRIPTION
This field displays the schedule object that specifies when this
condition applies. It displays none if this condition always applies.
This field displays the source address object of traffic to which this
condition applies. It displays any if this condition applies to traffic
from all source addresses.
This field displays the destination address object of traffic to which
this condition applies. It displays any if this condition applies to
traffic from all destination addresses.
This field displays whether users must log in (force) or whether
users do not have to log in (skip) when this condition is checked
and satisfied.
This column provides icons to add, edit, move, and remove
conditions.
To add a condition, click the Add icon at the top of the column or
next to each condition. If you click the one at the top of the
column, the new condition is first in the list. If you click the one
next to a condition, the new condition appears right below this
condition.
To edit a condition, click the Edit icon at the top of the column or
next to each condition. The Force User Authentication Policy
Add/Edit screen appears.
To remove a condition, click on the Remove icon next to the
condition. The Web Configurator confirms that you want to delete
the condition before doing so.
To move a condition up or down in the list, click on the Move to N
icon next to the condition, and type the line number (# field)
where you want to move this condition. The # field is updated
accordingly.
This is the total number of entries configured.
Click Apply to save the changes.
Click Reset to start configuring this screen again.
Vantage CNM User's Guide