Chapter 9 Device Network Settings
9.6 Auxiliary Interface
Use the Auxiliary screen to configure the ZyWALL's auxiliary interface. Click
Device Operation > Device Configuration > Network > Interface >
Auxiliary to open it.
Figure 125 Device Operation > Device Configuration > Network > Interface >
Auxiliary
Each field is described in the table below.
Table 113 Device Operation > Device Configuration > Network > Interface >
Auxiliary
LABEL
Auxiliary Interface Properties
Enable
Description
Port Speed
Dialing Type
290
DESCRIPTION
Select this to turn on the auxiliary dial up interface. The interface
does not dial out, however, unless it is part of a trunk and load-
balancing conditions are satisfied.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
Select the speed of the connection between the ZyWALL and external
computer.
Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
characters, and it can be
Vantage CNM User's Guide