Opening Vantage Report In Vantage Cnm - ZyXEL Communications Vantage CNM 2.3 User Manual

Note: Vantage Report has Standalone and Vantage CNM versions. Make sure you
install the Vantage Report in Vantage CNM version which is in the same
package of Vantage CNM. Vantage CNM cannot work with Vantage Report
Standalone version.
Click CNM System Setting > VRPT Management > Add. Configure the
2
Vantage Report instance in Vantage CNM, and select the devices that should send
log messages to the Vantage Report instance. See
When you click Apply, Vantage CNM automatically configures the selected devices
to send log messages to the specified Vantage Report instance. It does not change
any settings for log categories or traffic statistics.
Click CNM System Setting > Configuration > Log Setting for each device.
3
Make sure the desired log categories are selected and that traffic statistics are
sent to the Vantage Report server. Refer to Vantage Report 3.1 User's Guide for
more information.

29.4 Opening Vantage Report in Vantage CNM

After you set up a Vantage Report in Vantage CNM (see
556), select a device that is managed by Vantage Report, and click Log & Report
> VRPT. Then you can see the device's relative reports displayed via Vantage
Report in the Vantage CNM as shown next. Refer to Vantage Report User's Guide
for more detailed information.
Figure 304 Log & Report > VRPT (Vantage Report Main Screen)
Vantage CNM User's Guide
Chapter 29 VRPT
Section 30.6 on page
Section 29.3 on page
571.
557