Force User Authentication Policy Add/Edit Screen - ZyXEL Communications Vantage CNM 2.3 User Manual

Centralized network management

Hide thumbs Also See for Vantage CNM 2.3:

Table of Contents

Chapter 14 Object

14.3.2 Force User Authentication Policy Add/Edit Screen

Use this screen to specify a condition when users must log in or do not have to log

in to the ZyWALL before their HTTP traffic can pass through the ZyWALL.

Figure 163 Device Operation > Device Configuration > Object > User/Group >

Setting > Force User Authentication Policy Add/Edit

The following table describes the labels in this screen.

Table 146 Device Operation > Device Configuration > Object > User/Group > Setting

> Force User Authentication Policy Add/Edit

Authentication

Select this if you want this condition to be active.

Enter a description for this condition. It can be up to 60 printable ASCII

characters long.

Select whether users must log in (force) or whether users do not have

to log in (skip) when this condition is checked and satisfied.

Select a source IP address object or select Create Object to configure a

Select any if this condition applies to traffic from all source addresses.

Select the destination address of traffic to which this condition applies or

select Create Object to configure a new one. Select any if this

condition applies to traffic from all destination addresses.

Select the schedule object that specifies when this condition applies or

select Create Object to configure a new one. Select none if this

condition always applies.

Select this to save your changes and return to the previous screen.

Select this to return to the previous screen without saving any changes.

Vantage CNM User's Guide