17.6.6 Reset to Factory
Use this screen to restore anti-virus or IDP configuration to factory default to a
device. You can track the status and look at the results of this operation in the
Operation Report. See
device, click Device Operation in the menu bar and then click Configuration
Management > Signature Profile Management > Reset to Factory in the
navigation panel.
Note: At the time of writing, this screen is not available for ZLD-based ZyWALL.
Figure 210 Device Operation > Configuration Management > Signature Profile
Management > Reset to Factory
The following table describes the fields in this screen
Table 188 Device Operation > Configuration Management > Signature Profile
Management > Reset to Factory
TYPE
IDP/Anti-Virus
Reset to Factory
17.7 Configuration Building Block
Use this menu item to manage building blocks to the selected device. To open this
menu item, select the device, click the Device Operation in the menu bar and
Vantage CNM User's Guide
Section 27.6 on page
DESCRIPTION
Select the service whose configuration you want to manage.
Click this to reset the selected service configuration to factory
default.
Chapter 17 Configuration Management
549. To open this screen, select the
431