ZyXEL Communications Vantage CNM 2.3 User Manual page 270

Chapter 9 Device Network Settings
To display your ZyWALL's MAC filter settings, click Device Operation > Device
Configuration > Network > Interface > WLAN > MAC Filter. The screen
appears as shown.
Figure 113 Device Operation > Device Configuration > Network > Interface > WLAN
> MAC Filter
The following table describes the labels in this screen.
Table 105 Device Operation > Device Configuration > Network > Interface > WLAN
> MAC Filter
LABEL
Enable MAC
Filter
Association
#
MAC
Address
Description
Add icon
Apply
Reset
270
DESCRIPTION
Select or clear the check box to enable or disable MAC address filtering.
Enable MAC address filtering to have the router allow or deny access to
wireless stations based on MAC addresses. Disable MAC address filtering to
have the router not perform MAC filtering on the wireless stations.
Define the filter action for the list of MAC addresses in the MAC address
filter table.
Select Deny to block access to the router, MAC addresses not listed will be
allowed to access the router. Select Allow to permit access to the router,
MAC addresses not listed will be denied access to the router.
This is the index number of the MAC address.
This displays the MAC address (in XX:XX:XX:XX:XX:XX format) of the
wireless station that is allowed or denied access to the ZyWALL.
This field displays a descriptive name for the MAC address entry.
This column lets you create, edit, or remove MAC filter entries.
To create an entry, click the Add icon at the top of the column. The edit
screen appears.
To edit an entry, click the Edit icon next to it. The edit screen appears.
To remove an entry, click the Remove icon next to it. The ZyWALL confirms
you want to remove it before doing so.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Vantage CNM User's Guide