ZyXEL Communications Vantage CNM 2.3 User Manual page 156

Chapter 6 Device Security Settings
Table 53 Device Operation > Device Configuration > Security > VPN > VPN Rules
(Manual)
LABEL
Remote IP
Address
Encap.
IPSec
Algorithm
Remote
Gateway
Address
Add
Edit
Remove
156
DESCRIPTION
This is the IP address(es) of computer(s) on the remote network behind
the remote IPSec router.
This field displays N/A when the Remote Gateway Address field
displays 0.0.0.0. In this case only the remote IPSec router can initiate
the VPN.
The same (static) IP address is displayed twice when the Remote
Network Address Type field in the VPN - Manual Key - Edit screen is
configured to Single Address.
The beginning and ending (static) IP addresses, in a range of computers
are displayed when the Remote Network Address Type field in the
VPN - Manual Key - Edit screen is configured to Range Address.
A (static) IP address and a subnet mask are displayed when the Remote
Network Address Type field in the VPN - Manual Key - Edit screen is
configured to Subnet Address.
This field displays Tunnel or Transport mode (Tunnel is the default
selection).
This field displays the security protocols used for an SA.
Both AH and ESP increase device processing requirements and
communications latency (delay).
This is the static WAN IP address or domain name of the remote IPSec
router.
Click Add to add a new VPN policy.
Click this to modify an existing VPN policy.
Select a policy and click Remove to delete the VPN policy. A window
displays asking you to confirm that you want to delete the VPN rule.
When a VPN policy is deleted, subsequent policies move up in the page
list.
Vantage CNM User's Guide