Table of Contents
Advertisement
Vantage CNM 2.0
LABEL
Gateway
This is the IP address of the gateway. The gateway is an immediate neighbor of the
ZyXEL device that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as the ZyXEL device; over the WAN, the gateway
must be the IP address of one of the remote nodes.
Next
Select a page number or Next to view a particular page or next page of server entries
respectively.
Edit
Click a static route index number and then click Edit to set up a static route on the ZyXEL
device.
Click Apply to save your changes back to the ZyXEL device.
Apply
Reset
Click Reset to begin configuring this screen afresh.
10.1.2 Edit Static Route
LABEL
Route Name
Enter the name of the IP static route. Leave this field blank to delete this static route.
Active
This checkbox allows you to activate/deactivate this static route.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is
Address
always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number to
be identical to the host ID.
IP Subnet Mask
Enter the IP subnet mask here.
Gateway IP
Enter the IP address of the gateway. The gateway is an immediate neighbor of the ZyXEL
Address
device that will forward the packet to the destination. On the LAN, the gateway must be a
router on the same segment as the ZyXEL device; over the WAN, the gateway must be
the IP address of one of the Remote Nodes.
10-2
Table 10-1 Configuration > Static Route
Figure 10-2 Configuration > Static Route > Edit
Table 10-2 Configuration > Static Route > Edit
DESCRIPTION
DESCRIPTION
Configuration > Static Route
Advertisement
Table of Contents
