ZyXEL Communications Vantage CNM 2.3 User Manual page 304

Chapter 9 Device Network Settings
Table 119 Device Operation > Device Configuration > Network > Routing > Policy
Route > Edit (continued)
LABEL
Description
Criteria
User
Incoming
Source Address Select a source IP address object.
Destination
Address
Schedule
Service
Next-Hop
Type
Gateway
VPN Tunnel
Trunk
Interface
Address
Translation
304
DESCRIPTION
Enter a descriptive name of up to 31 printable ASCII characters for the
policy.
Select a user name or user group from which the packets are sent.
Select an interface or VPN tunnel through which the incoming packets
are received.
Select a destination IP address object.
Select a schedule or select Create Object to configure a new one.
none means the route is active at all times if enabled.
Select a service or service group from the drop-down list box.
Select Auto to have the ZyWALL use the routing table to find a next-hop
and forward the matched packets automatically.
Select Gateway to route the matched packets to the next-hop router or
switch you specified in the Gateway field. You have to set up the next-
hop router or switch as a HOST address object first.
Select VPN Tunnel to route the matched packets via the specified VPN
tunnel.
Select Trunk to route the matched packets through the interfaces in the
trunk group based on the load balancing algorithm.
Select Interface to route the matched packets through the specified
outgoing interface to a gateway (which is connected to the interface).
This field displays when you select Gateway in the Type field. Select a
HOST address object. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. The gateway
must be a router or switch on the same segment as your ZyWALL's
interface(s).
This field displays when you select VPN Tunnel in the Type field. Select
a VPN tunnel through which the packets are sent to the remote network
that is connected to the ZyWALL directly.
This field displays when you select Trunk in the Type field. Select a
trunk group to have the ZyWALL send the packets via the interfaces in
the group.
This field displays when you select Interface in the Type field. Select
an interface to have the ZyWALL send traffic that matches the policy
route through the specified interface.
Use this section to configure NAT for the policy route. This section does
not apply to policy routes that use a VPN tunnel as the next hop.
Vantage CNM User's Guide