ZyXEL Communications Vantage CNM 2.3 User Manual page 296

Chapter 9 Device Network Settings
Table 115 Device Operation > Device Configuration > Network > Interface > Trunk >
Edit (continued)
LABEL
Mode
Weight
Downstream
Bandwidth
Upstream
Bandwidth
Spillover
Add icon
Apply
Cancel
296
DESCRIPTION
Select Active to have the ZyWALL always attempt to use this connection.
Select Passive to have the ZyWALL only use this connection when all of
the connections set to active are down. You can only set one of a group's
interfaces to passive mode.
This field displays with the weighted round robin load balancing
algorithm. Specify the weight (1~10) for the interface. The weights of the
different member interfaces form a ratio. This ratio determines how much
traffic the ZyWALL sends through each member interface. The higher an
interface's weight is (relative to the weights of the interfaces), the more
traffic the ZyWALL sends through that interface.
This field displays with the least load first load balancing algorithm. It
displays the maximum number of kilobits of data the ZyWALL is to allow
to come in through the interface per second.
This field displays with the least load first or spillover load balancing
algorithm.It displays the maximum number of kilobits of data the
ZyWALL is to send out through the interface per second.
This field displays with the spillover load balancing algorithm. Specify the
maximum bandwidth of traffic in kilobits per second (1~1048576) to
send out through the interface before using another interface. When this
spillover bandwidth limit is exceeded, the ZyWALL sends new session
traffic through the next interface. The traffic of existing sessions still goes
through the interface on which they started.
The ZyWALL uses the group member interfaces in the order that they are
listed.
This column lets you add, remove and move trunk members.
To add an interface to the trunk, click an Add icon.To remove an interface
from a trunk, click the Remove icon next to it. The Vantage CNM
confirms you want to remove it before doing so.
To move an interface to a different number in the list, click the Move icon
next to it. In the field that appears, specify the number to which you want
to move the interface.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
Vantage CNM User's Guide