Advanced Modem Setup (Prestige) - ZyXEL Communications Vantage CNM 2.3 User Manual

Table 31 Device Operation > Device Configuration > Network > WAN Backup >
Advanced (Prestige) (continued)
LABEL
Multicast Version
PPP Options
PPP Encapsulation
Enable
Compression
Connection
Nailed-Up
Connection
Connect on
Demand
Max Idle Timeout
Budget
Allocated Budget
Period
Back
Apply
Reset

5.3.10 Advanced Modem Setup (Prestige)

Click Edit in the Advanced Modem Setup field. See
the configuration of this screen.
Vantage CNM User's Guide
DESCRIPTION
Select IGMP-v1 or IGMP-v2. IGMP version 2 (RFC 2236) is an
improvement over version 1 (RFC 1112) but IGMP version 1 is still in
wide use. If you would like to read more detailed information about
inter operability between IGMP version 2 and version 1, please see
sections 4 and 5 of RFC 2236.
Select CISCO PPP from the drop-down list box if your backup WAN
device uses Cisco PPP encapsulation; otherwise select Standard
PPP.
Select this check box to enable stac compression.
Select Nailed-Up Connection when you want your connection up
all the time. The device will try to bring up the connection
automatically if it is disconnected.
Select Connect on Demand when you don't want the connection up
all the time and specify an idle time-out in the Max Idle Timeout
field.
Specify an idle time-out in the Max Idle Timeout field when you
select Connect on Demand. The default setting is 0, which means
the Internet session will not timeout.
The configuration in the Budget fields has priority over your
Connection settings.
Type the amount of time (in minutes) that the dial backup
connection can be used during the time configured in the Period
field. Set an amount that is less than the time period configured in
the Period field. If you set the Allocated Budget to 0, you will not
be able to use the dial backup connection.
Type the time period (in hours) for how often the budget should be
reset. For example, to allow calls to this remote node for a maximum
of 10 minutes every hour, set the Allocated Budget to 10 (minutes)
and the Period to 1 (hour). If you set the Period to 0, there is no
budget control and the device uses the Connection settings.
Click this to return to the previous screen.
Click this to save the changes.
Click this to begin configuring this screen afresh.
Chapter 5 Device Network Settings
Section 5.3.5 on page 98 for
111