ZyXEL Communications Vantage CNM 2.3 User Manual page 280

Chapter 9 Device Network Settings
Each field is described in the table below.
Table 110 Device Operation > Device Configuration > Network > Interface > Bridge
> Add/Edit
LABEL
Bridge Interface Properties
Enable
Interface
Name
Description
Member Configuration
Available
Member
IP Address Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Interface Parameters
280
DESCRIPTION
Select this to enable or clear this to disable this interface.
This field is read-only if you are editing the interface. Enter the name
of the bridge interface. The format is brx, where x is 0 - 11. For
example, br0, br3, and so on.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
This field displays Ethernet interfaces and VLAN interfaces that can
become part of the bridge interface. An interface is not available in
the following situations:
• There is a virtual interface on top of it
• It is already used in a different bridge interface
Select one, and click the select arrow to add it to the bridge
interface. Each bridge interface can only have one VLAN interface.
This field displays the interfaces that are part of the bridge interface.
Select one, and click the deselect arrow to remove it from the bridge
interface.
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address, subnet mask, and gateway
automatically.
Select this if you want to specify the IP address, subnet mask, and
gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL sends packets to
the gateway when it does not know how to route the packet to its
destination. The gateway should be on the same network as the
interface.
Enter the priority of the gateway (the ISP) on this interface. The
ZyWALL decides which gateway to use based on this priority. The
lower the number, the higher the priority. If two or more gateways
have the same priority, the ZyWALL uses the one that was configured
first.
characters, and it can be
Vantage CNM User's Guide