ZyXEL Communications Vantage CNM 2.3 User Manual page 302

Chapter 9 Device Network Settings
Table 118 Device Operation > Device Configuration > Network > Routing > Policy
Route (continued)
LABEL
Schedule
Incoming
Source
Destination
Service
Next-Hop
SNAT
BWM
Add icon
Total Records
Apply
Reset
302
DESCRIPTION
This is the name of the schedule object. none means the route is active
at all times if enabled.
This is the interface on which the packets are received.
This is the name of the source IP address (group) object. any means all
IP addresses.
This is the name of the destination IP address (group) object. any means
all IP addresses.
This is the name of the service object. any means all services.
This is the next hop to which packets are directed. It helps forward
packets to their destinations and can be a router, VPN tunnel, outgoing
interface or trunk.
This is the source IP address that the route uses.
It displays none if the ZyWALL does not perform NAT for this route.
This is the maximum bandwidth allotted to the policy. 0 means there is
no bandwidth limitation for this route.
Click the Add icon in the heading row to add a new first entry.
Click the Edit icon to go to the screen where you can edit the routing
policy on the ZyWALL.
Click the Add icon in an entry to add a rule below the current entry.
Click the Remove icon to delete an existing routing policy from the
ZyWALL. A window displays asking you to confirm that you want to delete
the routing policy.
In a numbered list, click the Move to N icon to display a field to type a
number for where you want to put that rule and press [ENTER] to move
the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of
their numbering.
This field displays the total number of policy routes.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Vantage CNM User's Guide