ZyXEL Communications Vantage CNM 2.3 User Manual page 291

Table 113 Device Operation > Device Configuration > Network > Interface >
Auxiliary (continued)
LABEL
Initial String
Auxiliary Configuration
Phone Number Enter the phone number to dial here. You can use 1-20 numbers,
User Name
Password
Retype to
confirm
Authentication
Type
Timeout
Idle Timeout
Apply
Reset
Vantage CNM User's Guide
DESCRIPTION
Enter the AT command string to initialize the external modem.
the most common string, but you should check the manual for the
external modem for additional commands.
commas (,), or plus signs (+). Use a comma to pause during dialing.
Use a plus sign to tell the external modem to make an international
call.
Enter the user name required for authentication.
Enter the password required for authentication.
Enter the password again to make sure you have not typed it
incorrectly.
Select the authentication protocol to use for outgoing calls. Choices
are:
Chap/PAP - The ZyWALL accepts either CHAP (Challenge Handshake
Authentication Protocol) or PAP (Password Authentication Protocol),
as requested by the computer you are dialing.
Chap - The ZyWALL accepts CHAP only.
PAP - The ZyWALL accepts PAP only.
MSCHAP - The ZyWALL accepts MSCHAP only.
MSCHAP-V2 - The ZyWALL accepts MSCHAP-V2 only.
Type the number of seconds the ZyWALL tries to set up a connection
before it stops. Allowed values are 30 - 120.
Type the number of seconds the ZyWALL should wait for traffic before
it automatically disconnects the connection. Set this field to zero to
disable the idle timeout. Allowed values are 0 - 360.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 9 Device Network Settings
is
ATZ
291