Chapter 9 Device Network Settings
Figure 117 Device Operation > Device Configuration > Network > Interface > VLAN
> Add/Edit - DHCP Server Settings
Figure 118 Device Operation > Device Configuration > Network > Interface > VLAN
> Add/Edit - DHCP Relay Settings
Each field is explained in the following table.
Table 108 Device Operation > Device Configuration > Network > Interface > VLAN >
Add/Edit
LABEL
VLAN Interface Properties
Enable
Interface
Name
Port
Virtual LAN
Tag
Description
IP Address Assignment
Get
Automatically
Use Fixed IP
Address
274
DESCRIPTION
Select this to turn this interface on. Clear this to disable this interface.
This field is read-only if you are editing an existing VLAN interface.
Enter the number of the VLAN interface. You can use a number from
0~4094.
Select the Ethernet interface on which the VLAN interface runs.
Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN.
Allowed values are 1 - 4094. (0 and 4095 are reserved.)
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address, subnet mask, and gateway
automatically.
You should not select this if the interface is assigned to a VRRP group.
Select this if you want to specify the IP address, subnet mask, and
gateway manually.
characters, and it can be
Vantage CNM User's Guide