ZyXEL Communications Vantage CNM 2.3 User Manual page 262

Chapter 9 Device Network Settings
Table 101 Network > Interface > WLAN > Add (No Security) (continued)
LABEL
Security Type
802.1x
Radius Server
IP Address
Radius Server
Port
Radius Server
Secret
IP Address Assignment
IP Address
Subnet Mask
Interface Parameters
Upstream
Bandwidth
Downstream
Bandwidth
MTU
DHCP Settings
DHCP
262
DESCRIPTION
Use this field to select the type of security to use for this wireless LAN
interface. Select none to not use any security. See the following
sections for details on the other security types.
Authentication server (IEEE 802.1x) settings are available when you
use no security or WEP security.
Select the check box to enable wireless user authentication through an
external authentication server.
Enter the IP address of the external authentication server in dotted
decimal notation.
Enter the RADIUS server's listening port number (the default is
1812).
Enter a password (up to 31 alphanumeric characters) as the key to be
shared between the external authentication server and the ZyWALL.
The key is not sent over the network. This key must be the same on
the external authentication server and ZyWALL.
Enter the IP address for this interface.
Enter the subnet mask of this interface in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can send through the interface to the network. Allowed values
are 0 - 1048576. This setting is used in WAN load balancing and
bandwidth management.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the
ZyWALL can receive from the network through the interface. Allowed
values are 0 - 1048576.
Maximum Transmission Unit. Type the maximum size of each data
packet, in bytes, that can move through this interface. If a larger
packet arrives, the ZyWALL divides it into smaller fragments. Allowed
values are 576 - 1500. Usually, this value is 1500.
Select what type of DHCP service the ZyWALL provides to the wireless
network. Choices are:
None - the ZyWALL does not provide any DHCP services. There is
already a DHCP server on the network.
DHCP Relay - the ZyWALL routes DHCP requests to one or more
DHCP servers you specify. The DHCP server(s) may be on another
network.
DHCP Server - the ZyWALL assigns IP addresses and provides subnet
mask, gateway, and DNS server information to the network. The
ZyWALL is the DHCP server for the network.
These fields appear if the ZyWALL is a DHCP Relay.
Vantage CNM User's Guide