Configuring A Default Radius Server - ZyXEL Communications Vantage CNM 2.3 User Manual

Chapter 15 AAA

15.3 Configuring a Default RADIUS Server

User this screen to configure the default external RADIUS server to use for user
authentication. Click Device Operation > Device Configuration > Object >
AAA Server > RADIUS to display the screen as shown.
Figure 178 Device Operation > Device Configuration > Object > AAA Server >
RADIUS > Default
The following table describes the labels in this screen.
Table 161 Device Operation > Device Configuration > Object > AAA Server >
RADIUS > Default
LABEL
Host
Authentication
Port
Key
Timeout
Apply
Reset
390
DESCRIPTION
Enter the IP address (in dotted decimal notation) or the domain name (up
to 63 alphanumeric characters) of a RADIUS server.
The default port of the RADIUS server for authentication is 1812.
You need not change this value unless your network administrator
instructs you to do so with additional information.
Enter a password (up to 15 alphanumeric characters) as the key to be
shared between the external authentication server and the ZyWALL.
The key is not sent over the network. This key must be the same on the
external authentication server and the ZyWALL.
Specify the timeout period (between 1 and 300 seconds) before the
ZyWALL disconnects from the RADIUS server. In this case, user
authentication fails.
Search timeout occurs when either the user information is not in the
RADIUS server or the RADIUS server is down.
Click Apply to save the changes.
Click Reset to start configuring this screen again.
Vantage CNM User's Guide