Chapter 24 3G Monitor
The following table describes the labels in this screen.
Table 234 Monitor > 3G Monitor > Monitor Setting > Notification Setting
LABEL
Notification trigger
events
Go to configure
notification content
Apply
Reset
24.6.2 Notification
Use this screen to customize the notification message that you want to receive
from Vantage CNM.
524
DESCRIPTION
Select the trigger events of which you want to be notified.
•
Signal strength is weaker than (value) dBm during (value)
minutes
•
When over (value)% of time budget or (value)% of data
budget Primary/Backup WAN Fail-over
•
3G Card is not installed while 3G is enabled
Note that you can customize the value for signal strength. Specify
the dBm value and the length of time this state persists. The
default values are -78 dBm and 1 minute.
You can also specify the time budget and data budget ratio. The
default value for both is 50.
Click this link to customize the notification message that you want
to receive from Vantage CNM.
Click this to save your settings.
Click this to change the settings in this screen to the last-saved
values.
Vantage CNM User's Guide