ZyXEL Communications Vantage CNM 2.3 User Manual page 158

Chapter 6 Device Security Settings
Table 54 Device Operation > Device Configuration > Security > VPN > VPN Rules
(Manual) > Add/Edit (continued)
LABEL
Name
Allow NetBIOS Traffic
Through IPSec Tunnel
Local / Remote Network
Starting Address
Ending Address/Subnet
Mask
Gateway Policy Information
My ZyWALL
Remote Gateway Address
Manual Proposal
SPI
Encapsulation Mode
158
DESCRIPTION
Type up to 32 characters to identify this VPN policy. You may
use any character, including spaces, but the Vantage CNM
drops trailing spaces.
NetBIOS (Network Basic Input/Output System) are TCP or
UDP packets that enable a computer to find other computers.
It may sometimes be necessary to allow NetBIOS packets to
pass through VPN tunnels in order to allow local computers to
find computers on the remote network and vice versa.
Select this check box to send NetBIOS packets through the
VPN connection.
Local / Remote IP addresses must be static and correspond to
the remote IPSec router's configured remote IP addresses.
Two active SAs cannot have the local and remote IP
address(es) both the same. Two active SAs can have the
same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP
addresses, as long as only one is active at any time.
When the Address Type field is configured to Single, enter
a (static) IP address on the LAN behind the device. When the
Address Type field is configured to Range, enter the
beginning (static) IP address, in a range of computers on the
LAN behind the device. When the Address Type field is
configured to Subnet, this is a (static) IP address on the LAN
behind the device.
When the Address Type field is configured to Single, this
field is N/A. When the Address Type field is configured to
Range, enter the end (static) IP address, in a range of
computers on the LAN behind the device. When the Address
Type field is configured to Subnet, this is a subnet mask on
the LAN behind the device.
This is the IP address of the local and remote computer(s) of
the VPN tunnel.
Type the IP address of the computer with which you will make
the VPN connection or leave the field blank to have the device
automatically use the address in the Secure Gateway field.
Type a number (base 10) from 1 to 999999 for the Security
Parameter Index.
Select Tunnel mode or Transport mode from the drop-down
list box.
Vantage CNM User's Guide