Table of Contents
Advertisement
Chapter 7 Device Advanced Settings
7.6 Static Route
Use this screen to tell the device about networks that are not directly connected to the device.
To open this screen, click a device, click Device Operation in the menu bar and then click
Device Configuration > Advanced > Static Route in the navigation panel.
Figure 94 Device Operation > Device Configuration > Advanced > Static Route
The following table describes the labels in this screen.
Table 85 Device Operation > Device Configuration > Advanced > Static Route
LABEL
#
Route Name
Active
Destination
Gateway
Edit
Remove
7.6.1 Edit a Static Route
Use this screen to edit a static route in the device. To open this screen, select a static route, and
click Edit in the Device Operation > Device Configuration > Advanced > Static Route
screen.
202
DESCRIPTION
This is the number of an individual entry.
This is the name that describes or identifies this route. To delete a static route,
erase the name and then click Apply.
This field shows whether this static route is active or not.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is an immediate neighbor of the
device that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as the device; over the WAN, the gateway must
be the IP address of one of the remote nodes.
Click this to set up a static route on the device.
Click this to delete a static route.
Vantage CNM User's Guide
Advertisement
Table of Contents
Troubleshooting
