Dell PowerConnect M6348 Cli Reference Manual page 575

interface — Sets the relay server interface.
•
vlan-id — A valid VLAN ID.
•
• [remote-id {duid-ifid|
ID" sub-option to be added to relayed messages. This can either be the special keyword duid-
ifid, which causes the "remote ID" to be derived from the DHCPv6 server DUID and the
relay interface number, or it can be specified as a user-defined string.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel) mode
User Guidelines
relay-address
If is an IPv6 global address, then
link-local or multicast address, then
is not specified, then a value for
ALLAGENTS multicast address (i.e. FF02::1:2) is used to relay DHCPv6 messages to the relay
server.
Example
The following example configures VLAN 15 for DHCPv6 relay functionality.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 dhcp relay destination 2020:1::1
ipv6 dhcp relay-agent-info-opt
Use ipv6 dhcp relay-agent-info-opt command in Global Configuration mode to configure a
number to represent the DHCPv6 Relay Agent Information Option. The DHCPv6 Relay Agent
Information Option allows for various sub-options to be attached to messages that are being
relayed by the local router to a relay server. The relay server may in turn use this information in
determining an address to assign to a DHCPv6 client.
Syntax
ipv6 dhcp relay-agent-info-opt
option — Agent information option. (Range: 54-65535)
•
Default Configuration
option
The default value for
user-defined-string }] — The Relay Agent Information Option "remote
relay-interface
relay-interface
relay-interface
must be specified and the DHCPV6-
option
is 54.
is not required. If
is required. Finally, a value for
relay-address
is a
relay-address
575