Dell PowerConnect M6348 Cli Reference Manual page 975

Syntax
ip-address
permit ip-source
vlan-id
|port-channel
permit { ethernet interface-number
priority-value
[priority
service
permit service
priority-value
permit priority
interface-number — A valid routed port number.
• ethernet
vlan-id — A valid VLAN number.
• vlan
port-channel number — A valid port channel number.
•
ip-address — Source IP address.
•
mask — Specifies the network mask of the source IP address.
• mask
prefix-length — Specifies the number of bits that comprise the source IP address prefix.
• mask
The prefix length must be preceded by a forward slash (/). (Range: 0–32)
service — Indicates service type. Can be one of the following: telnet, ssh, http, https,
• service
tftp, snmp, or sntp.
priority-value — Priority for the rule. (Range: 1 – 64)
• priority
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with ethernet, vlan, and port-channel parameters are valid only if an IP address is defined
on the appropriate interface. Ensure that each rule has a unique priority.
Examples
The following example shows how to configure two management interfaces, Ethernet 1/g1 and
Ethernet 2/g9.
console(config)#management access-list mlist
console(config-macl)# permit ethernet 1/g1 priority <1-64>
console(config-macl)# permit ethernet 2/g9 priority <1-64>
console(config-macl)# exit
mask prefix-length
[ mask |
number service
] [ service
| vlan vlan-id
]
priority-value
[priority
] [ethernet
priority-value
] [ priority
| port-channel number
]
interface-number
| vlan
]
service
} [service
975
]