Maximum-Paths; Passive-Interface - Dell PowerConnect M6348 Cli Reference Manual

maximum-paths

Use the maximum-paths command in Router OSPFv3 Configuration mode to set the number
of paths that OSPF can report for a given destination.
Syntax
maximum-paths
no maximum-paths
maxpaths — Number of paths that can be reported. (Range: 1-2)
•
Default Configuration
2 is the default value for
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a destination to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1

passive-interface

Use the passive-interface command to set the interface or tunnel as passive. It overrides the
global passive mode that is currently effective on the interface or tunnel. Use the "no" form of
this command to set the interface or tunnel as non-passive.
Syntax
passive-interface {vlan
no passive-interface {vlan
vlan-id — The vlan number
•
tunnel-id — Tunnel identifier. (Range: 0–7)
•
Default Configuration
Passive interface mode is disabled by default.
820
maxpaths
maxpaths
.
vlan-id tunnel-id
| tunnel
vlan-id
| tunnel
}
tunnel-id
}